The use:

Widely used in various areas of aviation, at civil airports and in unobstructed airspace, helipads, iron towers, chimneys, ports, wind farms, high-rise bridges and places where aerial warning is required.

It is usually used above 45 m or below 150 m of buildings, it can be used alone, or it can also be used with low intensity OBL type B together.

Features:

• The light shade uses an anti-UV computer, which has a high light transmission efficiency of up to 90%, a relatively high impact resistance and is very well suited to a bad environment.
• The body of the light is made of stainless steel SUS304, the house of the light is made of aluminum alloy and painted with plastic spray, the structure is high strength and corrosion resistance.
• Special battery for solar energy, free maintenance and high reliability, lifespan more than 3 years.
• Based on the microprocessor of a single-chip computer, it is possible to precisely control charging and discharging.
• Mild steel glass Polycrystalline silicon solar panels, high energy efficiency (> 18%), service life more than 20 years.
• Move further using the optical design of the Fresnel lens.
• Also use the optical design of the reflector, more accurate visual distance, angle and thoroughly remove light pollution.
• The light source uses LEDs with a long life of up to 100,000 hours, lower energy consumption and high efficiency.
• Used photosensitive probe suitable for the natural curve of the light spectrum, automatic control of light intensity.
• The light circuit has a surge protector whose ability to withstand lightning is In 7.5KA / 5 times, Imax 15KA, so the light is suitable for harsh environments.
• Integrated design, IP65 protection lever.
• GPS sync is available.

Guide CM-13T medium intensity, type B Market.sk Slovakia

Installation:

（1） Integrated design for light （including solar panel, stainless steel holder, PC cover）.

（2） Install the light on a horizontal surface that has sufficient strength.

（3） Do not expose the photocell to light during installation, especially if there are any obstacles.

The use:

（1） Line identification, bulbs with one 4-core cable per 5 meters: the brown wire is marked "DC12V-", the blue wire is marked "signal", the yellow-green wire is the earth wire marked "Earth".

（2） To be able to store and deliver all lights go out before sending.

（3） There is a switch (as shown in the following figure) on the side of the bulb holder. When the bulbs are installed in place, you must press the switch on the bulb, then it can work normally. Switch next to the green light for the light level indicator. Green indicator Lamp illuminates in daylight, flashes at night twice every 3 seconds

Single light test:

If you need to test the light during the day to make sure the bulb is open, use an opaque material to cover the shade. At this time, start working with the flashing lights for about 10 seconds, which means that the lamp is working properly.

Warning:

• All cables must be connected correctly, otherwise the light may be damaged. Read the brand and introduction carefully.
• It is normal for the temperature to rise during operation of the bulbs.
• Do not open any part of the light body while the light is working to avoid danger
• Non-professional workers do not disassemble, once they are discovered, do not guarantee.